Headphone level

Moderator: flatmax

Post Reply
Posts: 4
Joined: Tue Jan 09, 2018 8:23 am

Headphone level

Post by escuta » Thu Apr 05, 2018 8:48 pm


Finally received my Audio Injector card after it languished in Brazilian customs for 3 months!

I'm hoping to to use the card in a headphone-based project and I find that the volume control pot does not control the level of the headphones (I haven't yet checked the line outs yet, but I assume it works on these). Can something be done to make the output pot control headphone level as well as the line out?

P.S. I tried searching the forum for this type of topic and received the following message: The following words in your search query were ignored because they are too common words: headphone level.

All the best

Posts: 608
Joined: Sat Jul 23, 2016 11:39 pm

Re: Headphone level

Post by flatmax » Tue May 08, 2018 8:25 pm

Hi there,

If you can use the Zero board, then you can connect through a pot. on the IO board. Otherwise, you need to use software.

Checkout the next kickstarter campaign - the Ultra 2 : https://kck.st/2xwM3DL
Please review the Zero sound card on Amazon USA : https://www.amazon.com/dp/B075V1VNDD
Check out our new forum on github : https://github.com/Audio-Injector

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests