Pot next to RCA jacks labeled "in" not adjust headphone

Moderator: flatmax

Post Reply
milosz
Posts: 2
Joined: Mon Apr 02, 2018 8:45 am

Pot next to RCA jacks labeled "in" not adjust headphone

Post by milosz » Mon Apr 02, 2018 9:08 am

What does the pot next to the "IN" RCA jacks do?

Neither pot has any effect on headphone volume using mpc as a source.

I've got an AUDIO DEVICE SETTINGS gui panel for audioinjector-pi-soundcard (Also mixer) and I have two slides on it, with "Master" above them, one slider has a button with a speaker icon below it, the other slider has a "chain link" button below it... the sliders move in unison, and raise / lower the output from the 3.5 mm headphone jack... not sure exactly how the buttons work or what exactly these two sliders actually are doing in the circuit....
Image

Is there documentation on this some place?

Is there a setting I need to invoke in order for one of the pots to adjust headphone volume?

flatmax
Posts: 609
Joined: Sat Jul 23, 2016 11:39 pm

Re: Pot next to RCA jacks labeled "in" not adjust headphone

Post by flatmax » Tue May 08, 2018 8:23 pm

Hi there,

On the zero version of this sound card, you can use an IO board to pass the headphone out through a pot to the connectors.

Otherwise you have to use software - such as alsamixer.

Matt
Check out our audiophile quality crossovers : https://bit.ly/2kb1nzZ
Please review the Zero sound card on Amazon USA : https://www.amazon.com/dp/B075V1VNDD
---
Check out our new forum on github : https://github.com/Audio-Injector

milosz
Posts: 2
Joined: Mon Apr 02, 2018 8:45 am

Re: Pot next to RCA jacks labeled "in" not adjust headphone

Post by milosz » Tue May 08, 2018 9:33 pm

This is the card that I have, it is not the "zero" card, and it has a built-in headphone jack

Image

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests