Headphone level

[escuta]

Hello,

Finally received my Audio Injector card after it languished in Brazilian customs for 3 months!

I'm hoping to to use the card in a headphone-based project and I find that the volume control pot does not control the level of the headphones (I haven't yet checked the line outs yet, but I assume it works on these). Can something be done to make the output pot control headphone level as well as the line out?

P.S. I tried searching the forum for this type of topic and received the following message: The following words in your search query were ignored because they are too common words: headphone level.

All the best

[flatmax]

Hi there,

If you can use the Zero board, then you can connect through a pot. on the IO board. Otherwise, you need to use software.

Matt