Setting WM8731 parameters

Moderator: flatmax

Post Reply
AndreasSteil
Posts: 1
Joined: Tue Jun 06, 2017 12:13 am

Setting WM8731 parameters

Post by AndreasSteil » Fri Apr 27, 2018 11:29 pm

Hello,
is it possible to set WM8731 Audio CODEC parameter, e.g. to make it use a specific sample rate (BOSR) or the Filters to be used? If yes, where and how can I set the parameters (i.e. to write the relevant registers of the device)?
Thanks for an answer,
regards,
Andreas

flatmax
Posts: 609
Joined: Sat Jul 23, 2016 11:39 pm

Re: Setting WM8731 parameters

Post by flatmax » Tue May 08, 2018 8:15 pm

Hi there,

If you want to change the operation of the codec, probably the best place to alter register settings is in the codec driver :
https://github.com/raspberrypi/linux/bl ... s/wm8731.c

Matt
Check out our audiophile quality crossovers : https://bit.ly/2kb1nzZ
Please review the Zero sound card on Amazon USA : https://www.amazon.com/dp/B075V1VNDD
---
Check out our new forum on github : https://github.com/Audio-Injector

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests