Breakout connections
Moderator: flatmax
Breakout connections
Can you please tell me if the attached connections correct?
- Attachments
-
- see.jpg (234.86 KiB) Viewed 1422 times
Re: Breakout connections
Hi there,
Here is a connection diagram :
Key thing is to make sure the preamp is plugged correctly into the Octo sound card. The mechanical holes should line up perfectly.
The speakers look right. For the microphones, if they are dynamic microphones, they should be ok, if however they are condenser microphones, they may require phantom power.
NOTE: This new thread also shows how to wire the system without the preamp, however care must be taken in reducing the ADC and DAC gains from full scale : http://forum.audioinjector.net/viewtopic.php?f=9&t=2987
Matt
Here is a connection diagram :
- Audio injector octo balanced breakout connection diagram
- octo.balanced.connectionDiagram.forum.jpg (221.91 KiB) Viewed 1420 times
The speakers look right. For the microphones, if they are dynamic microphones, they should be ok, if however they are condenser microphones, they may require phantom power.
NOTE: This new thread also shows how to wire the system without the preamp, however care must be taken in reducing the ADC and DAC gains from full scale : http://forum.audioinjector.net/viewtopic.php?f=9&t=2987
Matt
Check out our audiophile quality crossovers : https://bit.ly/2kb1nzZ
Please review the Zero sound card on Amazon USA : https://www.amazon.com/dp/B075V1VNDD
---
Check out our new forum on github : https://github.com/Audio-Injector
Please review the Zero sound card on Amazon USA : https://www.amazon.com/dp/B075V1VNDD
---
Check out our new forum on github : https://github.com/Audio-Injector
Who is online
Users browsing this forum: No registered users and 3 guests