Sound Installation for Gallery Exhibition

[Peter_Hoffmeister]

Hi Everyone,

I am looking to create an 8 channel audio installation for a gallery exhibition. I have a little beginner's experience with programming Arduino, but I am by no means even at an intermediate level. I have no Raspberry Pi experience, nor any Python experience. Is setting up the Octo Sound Card something a beginner could handle in your humble opinions?

Also, I would be looking to play the channels off an SD card since Bluetooth and WiFi are not options (it's a basement with lots of concrete walls).

Many thanks for any advice!

Best,

Peter

[flatmax]

There is an automated setup package for the Octo in this post.
You can get more support on this forum as well if you run into troubles.

For an installation, I would imagine that you will want to have a script which runs and simply loops over the audio in some way ? That would require some tinkering, however I can't see it as being too hard ...

Matt