Hello,
is it possible to set WM8731 Audio CODEC parameter, e.g. to make it use a specific sample rate (BOSR) or the Filters to be used? If yes, where and how can I set the parameters (i.e. to write the relevant registers of the device)?
Thanks for an answer,
regards,
Andreas
Setting WM8731 parameters
Moderator: flatmax
Re: Setting WM8731 parameters
Hi there,
If you want to change the operation of the codec, probably the best place to alter register settings is in the codec driver :
https://github.com/raspberrypi/linux/bl ... s/wm8731.c
Matt
If you want to change the operation of the codec, probably the best place to alter register settings is in the codec driver :
https://github.com/raspberrypi/linux/bl ... s/wm8731.c
Matt
Check out our audiophile quality crossovers : https://bit.ly/2kb1nzZ
Please review the Zero sound card on Amazon USA : https://www.amazon.com/dp/B075V1VNDD
---
Check out our new forum on github : https://github.com/Audio-Injector
Please review the Zero sound card on Amazon USA : https://www.amazon.com/dp/B075V1VNDD
---
Check out our new forum on github : https://github.com/Audio-Injector
Who is online
Users browsing this forum: No registered users and 4 guests